W-PROPS HIGHBACK

Two rods running along the back enhance the highback’s torsional performance and support. The sliding cushion on the upper inner side maintains freedom of movement for the boots. It delivers a high level of responsiveness, support, and freedom of movement essential for carving.

SLIDE PLATE

Low-friction materials are used to prevent interference with the boot’s lateral flex.

CARBON REINFORCED

Special carbon fiber is blended with domestically produced virgin nylon. This material, engineered for maximum lightness and strength, enables high-level board control.

REDUX LEAN ADJUSTER

Downsizing reduces weight. Adjustments can be made easily with a single action.

SLIDE HIGHBACK ROTATION

Tool-less highback rotation has evolved even further. You can easily adjust to your preferred angle without removing any screws.

TOOLLESS LEVER

Achieve the best setup without tools. Features a stopper to prevent screws from loosening.

MICRO ADJUSTER

Moving it one notch forward tilts the highback forward by approximately 2.5 degrees. Enables even finer highback adjustments.

WAFFLE STRAP

A two-layer structure combining a waffle cushion—which offers such a comfortable fit and freedom of movement that you’ll forget you’re wearing it—with a Power Strap that delivers direct power transfer.

F.T.M VER. 5.0

A strap designed exclusively for the Transfer model, featuring a reinforced center section to enhance power transfer, while the upper and lower ends are made more flexible to improve the fit with your boots.

L-GUIDE

Smoothly tucks away the strap to prevent it from catching on the snow during toeside turns.

BEER BUCKLE

A newly designed ratchet buckle that ensures a secure fit right down to the final tightening. It also features a bottle opener so you’re never stuck when it’s time to toast.

SUPER TRANSFER BASEPLATE

Thanks to the heel cup—which is approximately 15 mm higher than that of the Transfer Base—backside response is on a whole new level. It also reduces drag.

CARBON REINFORCED

Special carbon fiber is blended with domestically produced virgin nylon. This material, engineered for the ultimate balance of lightness and strength, enables high-level board control.

FLAT BOTTOM

The unevenness on the underside of the baseplate has been minimized to achieve a flat shape. This design maintains direct power transfer while also being considerate of the board’s topsheet.

4-CORNER STABILIZER

The stabilizer firmly yet gently transfers the powerful energy generated by the high heel cup to the board.

CARBON MULTI DISC

Rotary discs made from a specially blended carbon fiber lead to next-level mobility and responsiveness. A multi-disc compatible with both 4x4 and 2H setups. Installation is also possible with a 5mm or 10mm offset front-to-back or left-to-right.

BOOST CANTED FOOTON TH

The BOOTS FOOTON TH, which gained popularity thanks to Terje Haakonsen’s idea, has evolved even further.

By lowering the inner side compared to previous models, the overall height has been reduced while maintaining a cant angle. Minimizing changes in the highback area allows for seamless turns without any discomfort.

VIBRAM MEGAGRIP

The use of Vibram® Mega Grip on the footbed surface creates an unprecedented sense of unity with the boot. It significantly improves the feel underfoot and transmits the rider’s movements more directly to the board.

HEEL UP

The angled heel pedal supports edging during backside turns. It allows you to lift the board smoothly with minimal effort, enabling more efficient and precise turns.

ADJUSTABLE TOE & HEEL CUSHION

Movable cushions that can be adjusted separately on the toe and heel sides to match your boot size and board width.